IP35 Holding Tank

Comments 6

1. 

   Hayden 2013-06-06 14:58

   What tank monitor is this? Did you cut this into the EZELL tank?

   0 Likes

2. 

   Hayden 2013-06-06 14:59

   What tank monitor is this? Did you cut this into the EZELL tank?

   0 Likes

3. 

   Hayden 2013-06-06 14:59

   What tank monitor is this? Did you cut this into the EZELL tank?

   0 Likes

4. 

   Vladimir Petrovic 2013-06-09 15:52

   This is tech-edge PVC rod sensor that I cut into Ezell tank! https://tankedge.com/order.html. I connected it to their i-Series monitor. Installation was simple... Instructions were clear. Great support during the decision making and purchase. Most importantly, calibration was very simple. They are coming up with a new software that will be able to calculate volume of complicating shapes, like standrad Ezell tank. At the moment, volume is calculated as the level goes up and down the rod.

   0 Likes

5. 

   Vladimir Petrovic 2013-06-09 15:52

   This is tech-edge PVC rod sensor that I cut into Ezell tank! https://tankedge.com/order.html. I connected it to their i-Series monitor. Installation was simple... Instructions were clear. Great support during the decision making and purchase. Most importantly, calibration was very simple. They are coming up with a new software that will be able to calculate volume of complicating shapes, like standrad Ezell tank. At the moment, volume is calculated as the level goes up and down the rod.

   0 Likes

6. 

   Vladimir Petrovic 2013-06-09 16:07

   New Ezell tank, drilled a hole, installed Tech-edge PVC rod sensor using pipe holder 1" and glued with 3M 5200 plus four screwes.

   0 Likes

Log in to write a comment.