Nav Station Re-do

This is the new panel still covered over with masking tape to prevent chips in the black face when work is being done… — This is the new panel still covered over with masking tape to prevent chips in the black face when work is being done on it. On the right is the cut-out for the sub panel. Just to the left of that is the cut-out for the wind generator panel, now reduced in size. To the left of that will be an i70 display and below that will be the controls for the charger/inverter and the genset. In the center are the controls for the Espar heater, tri-anchor light, remote solar controller and the holding tank monitor. The space under the sub panel is being left open to make space for a larger panel if it's ever needed. Might put one of those DC outlets in there since that's considered expendable if we ever have another need for that space. I'm much happier with this layout. I also plan to put a hinged plexiglass cover over the sub panel to protect the breakers. Normally our computer monitor covers up the right half of this panel so the gear that's used more often was placed to the left.

By: Cheri + Tom Ward
Added: 25 October 2015
Album: Nav Station Re-do
Category: Electronics
Views: 704

0

Comments 0

No comments yet.

Log in to write a comment.

Disclaimer

Sincerely,

The International IPYOA administration team.