Rub Rail Screws

I've managed to obtain new rub rails for our IP 420 from Taco Marine.  According to Grok (AI), the screws should be #10 by 1.5" oval head.  I'm in Wyoming and the boat is in Mexico.  Can anyone verify this screw size?  I've had those rails off a few times.  My memory says the screws are closer to #8 by 1".  Grok's been known to make mistakes.  I've been know to make many more . 

Thanks for the help.
Dan
SV Karvi, IP420 Hull #6
On the Hard, Puerto Peñasco, Mexico

I received no replies, but I've learned the screws are #10x1inch Oval Head.

COngrats, glad to know.
MOST of us all are over on the FACEBOOK IPYIOA where 2,000 of us are very active. My site here is more of an archive. SOrry for the no reply.

Hayden